Seiko DPU-414 Manuel d'utilisateur télécharger pdf (Page 3)

G - 0 -17XX – DPU-414 - 0

Page 2 of 6



Printing With ACES Model 17XX Analyzers

The ACES Model 17XX series Analyzer allows you to print balance, rotor track and reports and

graphic spectra. Print options are presented throughout the various menus where applicable in a

given procedure. Printing can only be accomplished from the 1700 by using an Epson

Compatible Serial, Seiko DPU-414 or HP LaserJet II (or later) Laser Printer. An optional

serial-to-parallel printer converter may also be used for printing to parallel printers. The converter

and lab-tested printers are available from ACES Systems. You may purchase a similar converter

from your local electronic dealer, however; because of the numerous variations in design and

availability of technical data, ACES customer support can only provide support for the ACES

converter and associated printing problems. The communications / printer cable provided with the

analyzer is a serial communications cable for transfer of data to a personal computer, serial

printer, or serial-to-parallel converter. If using a parallel printer, you will also require a standard

printer cable (local purchase) configured for connection of the converter to your parallel printer.

This AppNote covers only the Serial printing function of the 17XX series analyzers to the Seiko

DPU-414 serial input. To print from the Analyzer:

1. Insure you have collected and stored data to print.

NOTE

If your analyzer has been previously setup for your printer application, skip to

item 6 below.

2. On the Analyzer:

a. Turn the analyzer ON by pressing the ON/OFF key.

b. Press the [SPCL MODES] key.

c. Select “1—Configure” and press [ENTER]

d. Select “7—Configure Printer” and press [ENTER]

1 2 3 4 5 6 7

Pas de commentaire

Seiko DPU-414 Manuel d'utilisateur Page 3