Seiko TM-L60 Manuel de l'opérateur télécharger pdf (Page 72)

(3)

Electrical characteristics

(a) Signal output current:

Maximum

-1 A (510 ms or less)

(b) Power ‘supply output voltage: 24 VDC (typical)

Maximum 1A (510 ms or less)

(d) Output waveform:

Refer to Figure B-2.

NOTE 1: These are not output

during

printing.

2: Drawer-kick drive signals L1 and L2 cannot be output at

the same time.

Drawer open/close signal

SW(+) signal level:

“LOW = 0 to 0.5 V

“HIGH” = 3 to 5 V

Printer side

User side

Figure El. Drawar kick-out Signal Interface Circuit

NOTE: Only the solenoid can be connected to the terminal of the

drawer-kick connector drive signal.

Figure B-2. Drawer kick-out Drive Signal

The waveform shown in Figure B-2. is output at Point A in Figure B-1 .

(n1 (ON time) and n2 (OFF time) depend on the

ESC p

command.)

See APPENDIX D Notes on Using the Drawer kick-out Connector.

-65-

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 84 85

Pas de commentaire

Seiko TM-L60 Manuel de l'opérateur Page 72