Seiko S651 Manuel d'utilisateur télécharger pdf (Page 29)

—26—

This section provides an overview of the wireless LAN interface board. For details

about this board, refer to the separate manual.

Connecting USB dongle

Connect the USB WiFi dongle that comes with the wireless LAN interface board to

the USB port connector.

To improve signal quality, you can also use a USB extension cable and adjust the

position of the dongle.

Panel button operation

Board operations are performed using the panel button on the rear of the LAN board.

 Enabling wireless LAN connection

Turn on the printer. Operation of this board will start about 20 seconds later.

 Printing wireless LAN setup information

Press the panel button.

 Entering setting mode

Hold down the panel button. A buzzer* will sound once to indicate that setting

mode has been entered.

• You can use setting mode to read factory settings.

• If you do not perform any operation for three seconds while in setting mode, a buzzer* will

sound once to indicate the board has returned to normal mode.

* Depending on the printer model and settings, the buzzer may not sound.

 Returning to factory settings

Enter the board setting mode, and then hold down the panel button. This returns

the board to its factory settings.

3.5 Wireless LAN Interface Board

CAUTION

 The board will automatically restart after this operation is complete. After clearing settings,

you will need to re-configure wireless LAN settings.

Panel button

USB port

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 57 58

Pas de commentaire

Seiko S651 Manuel d'utilisateur Page 29